Die vollautomatische -automatische Slotting-Maschine löst die Verarbeitungstechnologie der Wortkantenverarbeitung, wodurch die Kantenverarbeitung einfach und leicht zu bedienen ist und die einfach-zu verwendende- Slotting-Maschine ist CNC-Nuten während des gesamten Prozesses, automatische Berechnung der Schlitzgröße und der Länge des Seitenbands. Während des Nutvorgangs senkt und nutt der Winkelschleifer automatisch mit dem Sensor. Das präzise und stabile Nutsystem macht die Winkelschleif-Nutmaschine zu einer der am weitesten verbreiteten Geräte in der Branche.
The automatic slotting machine is a special equipment used to dig a groove of a certain width and depth on the flat side of the flat-edged lens when making half-frame glasses.
This equipment makes the tool mill an annular groove with a width of {{0}}.5mm (or 0.6mm) and a groove depth of about 0.3mm on the edge of the lens through the respective rotational movement of the processed lens and the tool, which is ready for assembly.
Methods and steps:
(1) The depth scale must be adjusted to the "0" position, and the two switches of the lens and the grinding wheel are in the OFF position.
(2) Use the accessory water dispenser to fully moisten the cooling sponge block with water.
(3) Clamp the lens as required to lower the machine head to the operating position, release the guide arm, the lens falls between the two nylon guide wheels, above the cutting wheel, turn the lens switch to the ON position, and make the lens rotate 1/4 turn Check to make sure it is in the proper position between the rollers, then turn on the cutting wheel switch, and finally adjust the depth dial to fix it at the position you set.
(4) After about 40s, the cutting sound will change, indicating that the lens slotting has been completed, then turn off the cutting wheel switch and the lens rotation switch, raise the machine head, and remove the lens.
(5) Check whether the groove depth and groove width of the lens meet the standard, especially whether the groove depth matches the position you set on the depth dial. If there is a deviation, the depth scale should be adjusted until it meets the requirements.
1. There is a small drain pipe fixed in front of the cutting wheel of the slotting machine, and a plug is prepared to prevent accidental splashing. This plug is often pulled to prevent excessive water accumulation and corrosion of the bearing.
2. Frequently clean the sponge to remove impurities and particles, and make it fully soaked before use. When the sponge is old, it must be replaced. It must be taken out and rinsed after daily use.
3. To reinstall the cutting wheel, first unplug the power plug, then insert a thin rod into the small hole of the shaft, and then unscrew the cross recessed head screw of the wheel.